In this film I give an overview of the modifications I've made to improve the performance of the cross slide on my 7x14 Chinese mini lathe. I replace the hard to use graduated dial, add bearings, increase the cross slide travel and make a replacement gib strip.
Details for the homemade aluminium anodising setup mentioned in the video: kzitem.info/news/bejne/rWiIsa6bcJSSfaw
Details for the homemade tailstock die holder mentioned in the video: kzitem.info/news/bejne/w4GVr6dtipOjq44
Details for the homemade rotary broach mentioned in the video: kzitem.info/news/bejne/2n6r3Xatpohigno
Approximate imperial sizes are shown. They're not direct equivalents, but are intended to give the non-metric viewer a rough feel for what I'm doing.
Made with subtitles -click the CC box.
-------------
For the material I couldn't capture myself, my thanks goes to the following:
Whoosh by Aysonny
freesound.org/people/Aysonny/sounds/414422/
Licensed under a Creative Commons Attribution 3.0 Unported License ( creativecommons.org/licenses/by/3.0/ )
-------------
Shot: HDC-HS700 1920x1080 50P AVCHD
Edit: FCP7 ProRes 422
Mic: DR-05
Негізгі бет Mini Lathe Cross Slide Improvements
Пікірлер: 165