like number 177,...thanx for the jutsu of shaft...wowsome result, greeting from Indonesia
@RYUKARYOTE
2 жыл бұрын
I wonder if filling the gap between the stock shaft and chassis with leftover POM is faster than the default setting!
@bilek8927
2 жыл бұрын
i suggest you using a clay instead or playdoh so its easier to replace instead of using POM
@RYUKARYOTE
2 жыл бұрын
@@bilek8927 thanks for the interesting recommendation, but the least regulations here in Korea are 'tamiya stuff only'..maybe manual paper might work?
@bilek8927
2 жыл бұрын
@@RYUKARYOTE it works fine too but be careful because sometimes the paper might fly into the motor and jammed. also a brake pad and a few layer of tape is also works you just need to adjust the thickness
@bilek8927
2 жыл бұрын
@@RYUKARYOTE and btw there's a tamiya brand clay no.37051,37052 that's what we using in the uk for full tamiya regulations
@RYUKARYOTE
2 жыл бұрын
@@bilek8927 thanks for the critical tip!
@jhervinsanchezarceo2151
Жыл бұрын
What motor to use for the gear 3.7:1 and 3.5:1.....im newbie
@markmartinez9031
Жыл бұрын
What app do you use on your cellular phone used for timer?
@GPBX01B
2 жыл бұрын
The improvement in speed was very small. However with those kit rollers still in place you may not be able to see the full potential benefit. It may have been better to use the Speed Checker.
@t-hirokihobbych
2 жыл бұрын
I have also done such verification in the past. kzitem.info/news/bejne/0J-ix6CEcpdzdWU
@underbonetv1371
2 жыл бұрын
What lap timer are you using?
@mohamedhanafiahkamal2745
Жыл бұрын
What app do you use for the timer?
@jay999tv
Жыл бұрын
What motor is good for ma?
@irenejoves6906
Жыл бұрын
Ultra/powerdash
@emilianosparaco8546
10 ай бұрын
Hyper dash/ mach dash for Bmax. Light dash Torque2 e Hyper for TMAC 😊
Пікірлер: 16