nice bit of kit, well worth working out a machine that works on the same principle
@joeltarrartistblacksmith
2 ай бұрын
I have another one of these a bit smaller too. I was using my new hydraulic press for a lot of these bends, but it's easy to overshoot the bend with a hydraulic press as you don't have the same feel/feedback through your hands.
@TalRohan
2 ай бұрын
@@joeltarrartistblacksmith yes I know what you mean about overshooting angles and theyre allmost impossible to put back without a lot of heating and careful rebanding. I havent bent anything big for a lot of years if I need an angle I usually cut and weld but if I could get one I'd use a bender a lot for the time it saves.
Пікірлер: 3