When the back gear was engaged durring the small test drive I did prior to buying this machine, it made a slight knock per revolution of the chuck.
I guessed then that the bull gear or cone gear had a damaged tooth, now is the time to see what I could do to fix it.
Apart from a bit of a cockup I made when I started my first cut, the tooth would have been right on the money. OK… so I made a mistake by forgetting to check the milling machine was properly secured, but its done now. Lets see how long it lasts...
Негізгі бет Тәжірибелік нұсқаулар және стиль Missing Back Gear Tooth. South Bend 13 (pt6)
Пікірлер: 145