Use BMF for years. It's quite easy and very realistic. Would like to see how you are working on curved areas like wheel wells (steady hand, NEW blade?) and even more how you are doing the side vents properly!
@MonsterHobbiesModelCarGarage
4 жыл бұрын
Good questions. I will have to find a car that has all of those chrome pieces and do a full BMF demonstration on it. I know the 1969 Oldsmobile has the chrome wheel wells, but the ultimate in BMF application is a 1958 Chevrolet.
@BGsModelWorkshop
4 жыл бұрын
Good technique Trevor!
@MonsterHobbiesModelCarGarage
4 жыл бұрын
Thank you! Cheers!
@michaelcooke2559
2 жыл бұрын
Nice video. BMF is great.
@MonsterHobbiesModelCarGarage
2 жыл бұрын
Glad you liked it. You must have watched it from the Corvette video.
@michaelcooke2559
2 жыл бұрын
@@MonsterHobbiesModelCarGarage Yes.
@bigcharliesmodelgarage296
4 жыл бұрын
Cool thanks for sharing Trevor
@MonsterHobbiesModelCarGarage
4 жыл бұрын
Any time!
@charlespalavros6952
4 жыл бұрын
Thanks for sharing ! Never done it got a 58 impala needs done
@MonsterHobbiesModelCarGarage
4 жыл бұрын
You can do it! That's a big job though.
@ronfleming6701
26 күн бұрын
It's all good
@MonsterHobbiesModelCarGarage
26 күн бұрын
Glad you found this video helpful! Chrome pens are also very useful.
@ScaleModelMuse
4 жыл бұрын
One of my fave detailing items
@MonsterHobbiesModelCarGarage
4 жыл бұрын
Thank you for watching!
@elmaster4938
Жыл бұрын
Great tutorial, just a questiok, before or after clear
@MonsterHobbiesModelCarGarage
Жыл бұрын
after.
@67bville
3 жыл бұрын
You waste a lot of foil. I cut strips a scale 3 inches and cut length to what I need with just a little extra. I can usually do about a dozen cars from one sheet.
@MonsterHobbiesModelCarGarage
3 жыл бұрын
That's a good tip Jerry. Are you using a scale ruler to get that width, or just "eye-balling"it?
@67bville
3 жыл бұрын
@@MonsterHobbiesModelCarGarage 1/8 inch is 3" in scale so no scale ruler is needed.
@MonsterHobbiesModelCarGarage
3 жыл бұрын
@@67bville Sounds good. I usually cut strips too. I might have over done it for this demo on my cutting. Hey....that's show-biz! :D
Пікірлер: 21