This video shows the servo drive we use on the layout in more detail. The servo motor is an SG90 180°. It fits snugly in a 15mm aluminum U profile, in which two screw holes are drilled as well as a 1mm hole that serves as the pivot point for the pin that moves the turnout. The pin is an unfolded paper clip.
We use Arduino for DCC control, loaded with the MARDEC software that can be downloaded for free from www.arcomora.c...]www.arcomora.com.
This software is a DCC servo- and accessory decoder and it's also used to tune the required servo angles for the two turnout positions.
Негізгі бет Model Railway 10 Turnout Servo Drive
No video
Пікірлер: 14