This is the beginnings of a Model Railway Control Panel which will be using an Arduino and a Loconet Interface board to connect to my Command Stations Loconet Interface. This will enable buttons to be pressed on the Control Panel and at the same time communicating with iTrain on my PC.
So if i operate a turnout on the Control Panel via the pushbuttons, it will be shown on iTrain and if I operate a turnout on iTrain it will change the LEDs on the Control Panel which shows the direction of the turnout.
Parts list:
Resistors all are 1/4w
R1 10k
R2 22k
R3 220k
R4 47k
R5 150k
R6 4.7k
R7 1k
R8 10k
R9 47 ohms
T1 BC337
T2 BC547
T3 BC547
IC1 LM311N
LED1 3mm LED
J1 Female 2.1mm DC PCB mount and/or 2 way PCB mount screw terminal block (5mm pitch)
JP1 4 way pin header (0.1 inch/2.54mm pitch)
LN1 RJ12 socket PCB mount (6P6C)
Big thanks to Luca Dentella for the informative videos and the Loconet Interface circuit board design/Arduino sketch. Check out his YT channel link below.
Luca Dentella KZitem
/ lucadentella
Loconet Interface Circuit Board only
www.pcbway.com/project/sharep...
Australian T Trak website
sites.google.com/view/austral...
T Trak, Ntrak website
www.ntrak.org
Kato Unitrack website
www.unitrack-kato.com/
Негізгі бет Автокөліктер мен көлік құралдары Model Railway Control Panel using Arduino and Loconet Interface
Пікірлер: 57