If I knew of a way to attach it to this video, I would.
@sushantmane1947
3 жыл бұрын
Which software it is
@advanceconsulting8417
2 жыл бұрын
OpenRoads Designer, by Bentley Systems.
@emjay0507
2 жыл бұрын
@@advanceconsulting8417 Is it possible in OpenBridgeModeler?
@advanceconsulting8417
2 жыл бұрын
@@emjay0507 I don't know. I have not used OBM.
@manuelsorianogaitero2434
Жыл бұрын
@@emjay0507 OpenBridge only builds smart solids for al bridge components, as decks, beams, columns, abutments, footings, piles, barriers, but it has not the technology, included in the itl files, to design the parametric components and points you have seen in the video.
@manuelsorianogaitero2434
Жыл бұрын
I good aproach, but a lot of time the aligment of the culvert has a skew angle with the road or rail aligment
@advanceconsulting8417
Жыл бұрын
Well, it's been a long time since I posted this video, but I would say that it would work for skewed culverts as well. The control baseline for the linear template is the back of the wall where it intersects with the proposed roadway fill slope. It does not have to be parallel with the roadway alignment.
Пікірлер: 13