Hello and welcome, thanks for stoping by. Today I'm installing the Tundra Rack. Overall, it was a long process dealing with the racks. Before you try to get the stock rack out raise the engine. Raising the engine a little will make it easier to remove and install the rack. Make sure to use your stock rack as a template for lining up the bushings, that will give you a decent starting point. You don't have to grind down the bungs, but it will give you a little more room. Pay attention to the high and low pressure lines, make sure they are not pressing up against the frame. I ended up with a solid shaft that was fabbed using the stock intermediate shaft slpine end and joint. Mine measured in at 13.59 inches overall complete length including the splines and joint. Have a good breakfast, it's going to be a long day. Don't rage quite. Steering feels like butter right now.
For ordering a Modded Tundra Rack hit up -- / basikbiker
Fab work video done to the Tundra Rack --
• Toyota Steering Rack a...
Both these studs are running Tundra Racks in Tacomas, they wheel way harder than I do. Many thanks for the helpful tips along the way.
IG Links --
/ kevinjbutts
/ 4lo_pro
Tools --
Hose Removal Tool -- amzn.to/3iWJP9e
Fluid Extractor -- amzn.to/3QUjTaZ
Flare Nut Wrench Set -- amzn.to/3wlR3ql
Pry Bar Set -- amzn.to/3Hph3HU
Shop Stool -- amzn.to/3D89frf
Angle Grinder -- amzn.to/3D6ciQO
Flap Disc set -- amzn.to/3Xy5CTU
Toyota Oil filter metal housing full kit -- amzn.to/3ZViEMQ
Shorter Aftermarket shaft -- amzn.to/3QFIXUA
Toyota Rack Bolts -- parts.toyota.com/p/BOLT---WIT...
Part Number - 90119 A0135.
Not 90119-A0137 these are to short.
#tundrarack
#tacoma
#shorts
Негізгі бет Автокөліктер мен көлік құралдары Modified Tundra Steering Rack install in a 3rd Gen Tacoma
Пікірлер: 73