That engine is so beautiful. It truly is a piece of art.. not just in an engineering sense but truly worthy of a plinth in an art museum!!
@JillTravenner
2 жыл бұрын
👌
@michaellipousky9143
2 жыл бұрын
Looks awesome good luck! I could not understand with your accent who makes the propeller? Maybe you could give me a link?
@jurijbatagelj6574
2 жыл бұрын
Thank you. Here you go… www.sl-propeller.de
@rolfandersen7558
2 жыл бұрын
Hi I see you got the moki 180. I just wonder if it fits inside the cowl?
@jurijbatagelj6574
2 жыл бұрын
It does perfectly
@rolfandersen7558
2 жыл бұрын
Thanks a lot. I will deffetly get the same also. Looks just awesome 👌
@HighwayDamage
2 жыл бұрын
i experienced those toprc gear motors to be too weak, however the legs are excelent, but you might wanna cut the springs inside them, they're a bit too hard. make sure you test then extensively and add some extra force with your finger while extending and retracting (to simulate turbulence forces) mine didnt had enough power to extend with a extra force, and didnt retract at all.
@jurijbatagelj6574
2 жыл бұрын
Ok I will do so. I have cycled them they seem to work ok….However I think it all depends on a power source you run those retracts. What was your solution ?
@HighwayDamage
2 жыл бұрын
@@jurijbatagelj6574 i tried with 8.4 volt but the motors were to weak, i exchanged the motors, using JP now, in flight the toprc motors didnt had enough power to fight against the turbulences.
Пікірлер: 10