Set-up instructions for the TentCraft 10x10 MONARCHREACH. The tool-free setup takes less than 2 minutes.
Key instruction points include:
1.Have two people stand on opposite sides of the tent. (If your setup includes a peak banner, install the hardware into the peak cap now.)
2. Have each person grab the scissor piece and walk backwards, gradually expanding the tent frame until you reach full extension.
3. Stand by a corner of the frame, place a foot on the plate at the end of the tent leg (foot pad).
4. Holding the tent down with your foot on the foot pad, press up on the scissor piece attached to the corner bracket as it slides up the leg and clicks into place. Repeat for remaining three legs.
5. Standing again by the tent leg with your foot on the foot pad (as in Step 5), extend the leg by pressing the push button in and pulling up on the leg until it snaps into place. Repeat for this leg until you have reached desired height. Repeat for remaining three legs.
6. Enjoy your MONARCHREACH
- Always properly ballast your tent with stakes or footplates -
This quick-deploy pagoda canopy tent model-also referred to as a pagoda marquee-is built with an all-aluminum heavy-duty framework for lasting quality. The entire event shelter expands into place in 60 seconds. Unlike traditional pop-up tent canopies, the pyramid-shaped roof provides an 18” overhang on all four sides, increasing both shade and tent capacity.
www.tentcraft....
Негізгі бет MONARCHREACH 10X10 Setup Video
Пікірлер