It's been driving me crazy trying to think of a way to do this! Thank you!
@RCmadness888
3 ай бұрын
Oh yeah, i have the same injection, got a old polo , it sat a long time, only 65k kms on the clock, original fuel filter, it was filthy, car run ok but i would still do this, just for peace of mind.
@dicksonkiyanga2414
Жыл бұрын
Learnt a thing or 2 from this test. By any chance what would be the ideal power source to use if a direct 12V might damage the injector?
@MeFixingEverything
Жыл бұрын
Current limited bench power supply
@MrEngineering12
4 ай бұрын
Do you have a video cleaning the Idle actuator valve (the one that pushes the throttle valve when idling?
@MeFixingEverything
4 ай бұрын
No
@XavLaz
Жыл бұрын
Thanks for you video, very intesting! Witch tension did you put on the injector ? 12v or 6v or less ? And other Quetion, to compare to you other vidéo where we can see droplet fall down from the injector, here on this vidéo we can see a real spray that what we need on the car ?
@MeFixingEverything
Жыл бұрын
12 v , you should not see droplets. Only very good spray, as fine as possible.
@XavLaz
Жыл бұрын
@@MeFixingEverything Thanks for your answer and for your vidéos !
@ronenfe
Жыл бұрын
What do I do if I have too lean mixture? Almost 0 voltage measured from the o2 sensor
@MeFixingEverything
Жыл бұрын
Too lean could be , fuel filter ,.fuel pump.. Check the pressure
@ronenfe
Жыл бұрын
@@MeFixingEverything I already checked it a few years ago. Pressure is good. Amount of fuel coming out in the return line was fine. I bought a seal kit to replace the seals of the injector. I will try to clean and replace the seals.
@dicksonkiyanga2414
Жыл бұрын
Was about to ask the reverse,what if its too rich? Also whats the ideal power source for the injector since a constant 12V would damage.
@ronenfe
Жыл бұрын
@@MeFixingEverything If I want to take the injector out, is there a way to clean it without turning it on?
@ronenfe
Жыл бұрын
The Renault manual says not to connect the injector directly to 12 volts for the Weber monopoint.
@MeFixingEverything
Жыл бұрын
Definitely don't connect for a long time , will burn the coil If you can use a bench power supply with regulated current.
@robertnebi8518
Ай бұрын
Can you yell me why my monopoint from polo 1.0 1995 ,eats to much gas,its going above 10 litres.
@MeFixingEverything
Ай бұрын
Don't know
@draganpopeye8230
7 ай бұрын
so that means if injector not spray like that its not good?
@MeFixingEverything
7 ай бұрын
If its not pulverised it's not that good Will Still work
@draganpopeye8230
7 ай бұрын
@@MeFixingEverything so i cleaned that injector and it working same as on video,but main problem is on my peugeot 205 1.1 second and third gear wont pull car. When i drive 1 gear is good and when i go to 2 or 3 engine dont have power in most cases it shut down idk what to do
Пікірлер: 21