I originally said 2/3rds the length of the servo arm. The cosine of 40 degrees is 0.766 and the cosine of 45 degrees is 0.707. So, 2/3rds might be a little too close unless you’re changing to a shorter arm for IMAC. Seems like a 3/4” arm is pretty short for a larger plane. I try to set both endpoints to 100% and adjust the sub trim and the pushrod length until the up and down throw are the same. Of course, I have to tweak the endpoints slightly. I like for them to be between 95 and 100 percent. I get 3D throw by turning the dual rates up to 125% or so. Btw, TXK is the airport identifier for Texarkana.. 🤠
@_D_K_2_3_
2 ай бұрын
Hey joe, do you fly wirh just one Futaba Receiver ? And how do you rout the antenna’s ? Thx and greetings from Austria 🇦🇹
@armandoabreu6593
2 ай бұрын
Hi Joe. What Dubro part number are those conical? Or do you make them up from different parts? Thanks.
@joehuntrc5027
2 ай бұрын
I tried to buy them from DUBRO but couldn't get a response. So, I buy them somewhere else. I'll look it up and post it soon. :)
Пікірлер: 6