If I just use the stickers will my axle be stronger.
@Tonygarry78
Жыл бұрын
Ha ha
@razorrayrowe9521
2 ай бұрын
So I have a 40 spline for lug 3/8 studs I need to drill out for 5/8 do you need to balance axle after this and do you do this type of work in house?
@stewaustin9758
Жыл бұрын
I have 2003 tj. W/broken rear axle. How can I count the splines to order the correct replacement (of of the axle ? ) How do I get out
@stewaustin9758
Жыл бұрын
The broken off spline end ???
@cerberus45
Жыл бұрын
might be easier to just identify your rear axle and go from there - since you have an '03 TJ and assuming your axles are original to the vehicle you'll either have a Dana 35 or Dana 44 in the rear.
@Benny-vn3mp
3 жыл бұрын
Is there anywhere that sells just the end bit of just the spline?
@mcqueenfanman
2 жыл бұрын
What are you building? I'd like to have some stub shafts made for a Ford 8.8 irs diff so I can use them in a vette. The vette output shafts are u joint style and act as part of the suspesion.
@gobenny3348
2 жыл бұрын
@@mcqueenfanman I’m building a cross kart and using an atv differential
@mcqueenfanman
2 жыл бұрын
@@gobenny3348 What is the spline count?
@gobenny3348
2 жыл бұрын
@@mcqueenfanman 24 spline, I already made one on a mill just need to start on the second
@Tonygarry78
Жыл бұрын
I just wanna replace my 19 spline with a 30 spline.
Пікірлер: 13