Dang yo, that's real insidious when the wires break inside the loom like that! Thankfully it wasn't the switch though, that would have been a little more involved to fix
@motormaniac1
4 жыл бұрын
Joe Garofalo II Well thank you sir! ❤️🍻 It would indeed have been terrible to fix that switch haha
@WizardKing-Official
2 жыл бұрын
Thank you man.
@jacksprat6825
Жыл бұрын
Good job
@albertptran
2 жыл бұрын
Thanks for sharing! I bet my short is hiding under the sleeve
@motormaniac1
2 жыл бұрын
Thank you! I’m glad I could help! ☺️ Shorts always seem to hide in the hardest to get to places 🤦🏼♂️
@kevinpickford8714
Жыл бұрын
Any advice for a horn thats stuck on as soon and the bike is on?
@luciano5137
8 ай бұрын
Also check the fuse my 750 kawa had a burnt fuse
@motormaniac1
3 ай бұрын
Good advice for sure! Always check fuses!
@OlderShadowRider
2 жыл бұрын
ty for the video, but I must have missed something, why did you put glue on the solder joints of the wire before pulling down your shrink wrap?
@motormaniac1
2 жыл бұрын
So that actually isn’t glue. It’s called “Rubber Cement”. It keeps the wires from shorting together. We don’t want the bare soldered joints to touch each other, because they will short out and ruin all the hard work. So we coated them with the rubber cement, to make sure they were protected from each other.
@sayeman9577
5 ай бұрын
thanks!
@motormaniac1
3 ай бұрын
My pleasure! 😊
@kylezeez378
4 жыл бұрын
changing out my tail light , failed 30 min after my inspection smh
@motormaniac1
4 жыл бұрын
Kyle zeez Oof! That’s no fun! Was it the bulb or a bad wire?!
@kylezeez378
4 жыл бұрын
@@motormaniac1 uh oh i didnt think of a bad wire, i bought a new light so lets hope it works
Пікірлер: 17