This is not a fully comprehensive discussion about all of the technical requirements for WERA. It's just some suggestions and discussion. The chief technical inspector at WERA ultimately has the final say whether your bike will pass tech and be allowed to race.
Content:
0:00 Introduction
0:45 Before you Drill and General Recommendations
4:27 Axles / Axle Nuts
5:17 Pinch Bolts
6:36 Brake Caliper Bolts
7:34 Brake Torque Arms
7:48 Speedometer and Tach Cables
8:06 Fork Oil Drain Bolt
8:46 Oil Fill Cap and Dipstick
9:08 Oil Drain Plug
9:51 Oil Gallery Plugs
10:45 Oil Lines
11:15 Oil Filter
11:24 Rear Exhaust Mounts
12:27 Kickstarter Retaining Bolt
12:35 Removable Exhaust Baffle
12:47 Radiator Cap
13:01 Coolant Drain
13:15 Pressure Fed Lubricant Line
13:23 Brake Pad Retaining Pins
13:42 Kickstand/Sidestand Removal
15:12 Coolant
15:28 Number Plates and Assignment
17:05 Bodywork
Brian Van's video about safety wiring:
• How To Safety Wire a M...
WERA Forum Discussion about Technical Requirements
forums.13x.com/index.php?thre...
Predrilled Fasteners and Clips from Kurvey Girl:
www.kurveygirl.com/
WERA Racer Numbers
www.wera.com/racers/Default.asp
Негізгі бет Motorcycle Technical Requirements for WERA
Пікірлер: 19