Lovely careful work. I did not see you change the bearing, I have ordered one. Did you change it off camera?
@UnauThorizedMechanic
Жыл бұрын
Thank you! My bearing was in perfect condition, there was no need to change it. Changing a bearing mounted on an aluminum support is a delicate operation, take all the necessary precautions. It's easy to ruin.
@jimmycav369
2 жыл бұрын
Bell video. Ho iniziato fare lo stesso intervento stasera sul mia mt03. Perdeva tanto refrigerante prima? Grazie
@UnauThorizedMechanic
2 жыл бұрын
Grazie, si ne perdeva abbastanza. Oltretutto era una perdita insidiosa perché si manifestava in maniera evidente a motore caldo e una volta spento finiva di gocciolare.
@jimmycav369
2 жыл бұрын
@@UnauThorizedMechanic grazie per la risposta. La mio perda appena, solo un goccio ogni tanto ma faccio per sicurezza appena arrivano i ricambi
@klmktmklm
6 ай бұрын
Ciao, ho una piccola perdita, qualche goccia dal premistop, piccolo foro sotto la pompa per intenderci, cambiando i seguenti componenti risolvo? Grazie
@UnauThorizedMechanic
6 ай бұрын
Ciao! Si è il sintomo che si è rovinata la tenuta della pompa dell'acqua. Cambiandola dovresti risolvere.
@mihaeltsf2231
Жыл бұрын
Hey i took my pump today out and i am not 100% sure what did you change and what i have to order
@UnauThorizedMechanic
Жыл бұрын
Ceramic water pump seals, Pump impeller shaft oil seal (under water pump seals), O-ring, Gasket.
@mihaeltsf2231
Жыл бұрын
On yamaha official home page could you say the nummbers of the parts i have everything on german :/
@mihaeltsf2231
Жыл бұрын
Or if you could send me a dm on instagram or something like that im in a real shitty possition right nov would need some help tbh
@UnauThorizedMechanic
Жыл бұрын
I don't know what the part numbers are anymore.
@UnauThorizedMechanic
Жыл бұрын
I advise you to download the workshop manual, and download an exploded view. So you can go to the spare parts dealer and ask him exactly what you need.
@FabioM.-qj2zt
8 ай бұрын
Ciao UTM, anche io dovrei fare lo stesso lavoro. Hai i file STL per stampare gli adattatori per innestare i cuscinetti? Grazie
@UnauThorizedMechanic
7 ай бұрын
Ciao quegli adattatori mi sono serviti per spingere il paraolio e la tenuta dell'acqua. I cuscinetti non gli ho mai smontati. Comunque mandami una email così te li passo.
Пікірлер: 17