that thing seems pretty simple, maybe i could even make one myself.
@clueless3891
8 жыл бұрын
Yes you can!
@Cloudisalwaysgray_id
6 жыл бұрын
Nice one!!! the result amazing. can you provide the motor, board and software? thanks.
@clueless3891
6 жыл бұрын
Thanks! Stepper motors - 28byj-48 upgraded to nema 17, spindle - johnson dc motor upgraded to dremel like engraver. Board Arduino uno R3 with cnc shield v3 (GRBLcompatible) A4988 stepper motor drivers. Software GRBL and Universal G code sender. All on Ali.E.
@Cloudisalwaysgray_id
6 жыл бұрын
Mirko Ivkovic thank you for information. Now my l293d will replace by cnc shield :). Anyway, is there any code for uno?
@clueless3891
6 жыл бұрын
xzx cx just flash GRBL
@Cloudisalwaysgray_id
6 жыл бұрын
thanks. subscribed!. :) anyway. did you using endstops? would be good if there's a article for this :)
@clueless3891
6 жыл бұрын
No, there is no need. Gear rack is smaller than half of the rail, if something happens gears just dont touch anymore. Article...it will be, someday.
Пікірлер: 29