Recommend watching at 1.5x speed.
this video shows what needs to be installed on the 2AR-FXE to fit in the Mr2 Spyder. This includes stock components, parts from a 2.5l Camry, and parts from the Frankenstien Motorworks swap kit. Plan is to make 260hp and launch this light car at 1G of acceleration.
TIS document link
drive.google.com/drive/folder...
00:00 removing flexplate
01:00 flywheel
01:50 clutch/pressure plate
03:05 throw-out bearing
03:40 bolts needed to mate transmission
05:00 installing transmission
06:50 shift mount
07:10 transmission-chassis mounts
07:30 starter and part number
07:45 hydraulic accumulator and bleeder
08:10 part numbers for bleeder/accumulator/line
08:30 water pump
09:05 belt tensioner
09:15 AC mount and belt part number
09:30 picture of oil filter haha
09:35 thermostat and custom coolant housing
09:46 alternator
10:00 coolant bypass line
10:10 custom header
10:30 sub harness needs to be replaced
10:50 fuel rail (injectors mentioned in previous video)
11:10 manifold tumble valve and install
11:35 small manifold mesh
12:00 making a custom dipstick
13:10 mounting harness
14:00 fuel end
14:15 wideband sensor
14:30 axle carrier bracket
Негізгі бет Тәжірибелік нұсқаулар және стиль Mr2 Spyder Project Car Part 3 - Engine externals/Accessories
Пікірлер: 1