i have a ms20 MKI, a MS20 mini and a MS20M - they all sound different. If i copy a patch from yt, i get different result on each of them. I think it also has to do with calibration of the machines. Sometimes some knobs just seem to go till 9 while other model ms 20 go to 11 if you understand what i mean, fully turned up.
@die5973
3 жыл бұрын
Thanks for the great comparison!
@SacSynths_Jack_Z
3 жыл бұрын
Thanks for doing this!
@harrylime6477
3 жыл бұрын
Thanks for taking the time sharing!
@SixPhilippe
2 жыл бұрын
Would love to see you handling the ms20/ms50 combo
@SwedishSynthLab
3 жыл бұрын
Great work!
@AdamTheAd-vanc3d
Жыл бұрын
In all honesty I'm torn between the 2 . The OTA defo sounds more refined and a less crunchy sounding especially on the resonance overtones. Both are lovely. The OTA seems to cut the low end a bit more deeper almost giving you a bass boost . Like a skateboarder descending a steep half pipe.
@chrisdickens4862
Жыл бұрын
The Korg-35 filter is really a rude, wild beast. Nothing else sounds like it. I love how it distorts when I have both oscillators detuned. I wonder why Korg switched from the 35 to the OTA-based filter. By giving it a fairly generic filter, I feel the synth loses character in the process. Not that I don’t like standard OTA filters, but the 35 was unique. Thanks for the comparison.
@RichardQuirkmusic
2 жыл бұрын
thanks for posting this, great comparison. Have you tried both of these against the newer Korg MS-20 FS?
@Lackan110f
2 жыл бұрын
Hi, no I have not, but it was when I briefly had a Behringer K2 that I got curious since I didn't think it sounded like how I remembered at all. So I decided on getting a vintage again (the OTA, the K35 is from a friend of mine) To me all clones sound OK, but if you want a MS20 only a MS20 will do. :)
@mmrva
3 жыл бұрын
Grrrrreat demo! So that front panel screw for OTA daughter board is a valid determination detail?
@Lackan110f
3 жыл бұрын
Thanks! No, not really. The screw is for fastening the heatsink. The regulators/PSU are right behind there. The OTA board is attached with plastic stand-offs further to the left. But it seems that they started with the screw around the same time when they revised the PCB for the new filter. So IMO - pretty accurate, but not 100%.
Пікірлер: 16