Perfect example. I've seen a lot of videos where people incorrectly measure from the center of the swing arm. I'm glad you point out to measure from the end of the chain gaurd at it's lowest point as instructed in the owners manual.
@madnjpn
5 ай бұрын
Thanks a lot! The picture in the manual is a bit confusing, and people around different forums seem to measure incorrrectly. Some measure from the flat plastic above the rib, not the rib itself. Take care
@ClearBrookExotics
6 жыл бұрын
I found, like you said below, the measurement was within a couple of mm whether the bike is on the side stand or rear wheel off the ground. And it sure is easier with the bike on a rear stand, especially if you have to actually loosen the slack to get it even on both sides.
@2lbsTrigrPull
3 жыл бұрын
Make sure the stars and the moon all align correctly when clipping on a 3.001 to be exact pound weight to the chain and the shadow of the sun shall not be hitting at an angle over 45° so that there is absolutely no error in the chain tension because any variation of the perfect tension will destroy your bike in no time. Trust me, I adjusted the chain by feeling and it's still working after 20.000km.
@ToxicF4TE
3 жыл бұрын
😂
@truehonesty7247
8 жыл бұрын
Do you measure the distance when the bike is on its side stand or when the wheel is off the floor ? Thanks
@stevieb6414
8 жыл бұрын
The manual says to do it on the side stand but I found it doesn't matter if the rear wheel is on or off the ground like when using a paddock stand
@rclines001
5 жыл бұрын
Never really understood that part. Whether it's on the side stand or on a rear wheel stand, it's going to have the same amount of down pressure on the back swing arm. Should be identical.
@pauljones-tj5vs
6 жыл бұрын
Great tip, thanks.
@fabiodual94
4 жыл бұрын
to measure correctly you have to take the center of the chain where it connects?
@stevieb6414
4 жыл бұрын
Not sure I understand, the centre of the chain should be inline with the end of the proudest part of the chain guard, you then measure from there to the centre of the link as shown in the video
@hannesRSA
Жыл бұрын
Thanks, the manual was pretty vague
@hubi143
6 жыл бұрын
QUESTION MAN HOW TO I LOOSEN THE Drive chain slack adjusting plate, the other line is way off 4 - 5, i dont know how to adjust it
@stevieb6414
6 жыл бұрын
Hi you need to look at this www.bing.com/videos/search?q=mt07+drive+chain+adjustment&view=detail&mid=7CFF918B4B23928B79DE7CFF918B4B23928B79DE&FORM=VIRE
Пікірлер: 15