DIY Home Security - New Video: • DIY Simple PIR Motion ...
In this tutorial, we will learn how to use multi-servo with Arduino. We will control 4 servo motors with Arduino PWM outputs.You can implement your robotic arm projects with reference to this tutorial. Of course we will use external battery / power when doing this.
In the next tutorial, I'll show you how to use multiple servos with potentiometers. Do not forget to subscribe. Thank you for your support.
I did not share the code because it is short and it varies according to the number of servos. You can write code by watching the tutorial. This is a better way to learn. I will continue to share long and complex codes.
Required Hardware
Arduino Board:
goo.gl/UyGYeF
amzn.to/2LZr6t4
Servo Motor x4 :
goo.gl/iOkPgu
amzn.to/3avwe1N
Wires :
goo.gl/VRzUN4
amzn.to/3doetmT
Breadboard :
goo.gl/yCa8hX
amzn.to/3qxLxwm
Recommended Items:
Use Your Muscles in Project - amzn.to/3wdL45C
37 Sensor & Module Packages - amzn.to/3m66WeQ
Try this Robot Arm - amzn.to/3fq8DCl
Best Resin 3D Printer - amzn.to/39tY8KB
Arduino Compatible Kits - bit.ly/2J2AFF7
Connections:
The external battery VCC / GND connect to the breadboard.
The Arduino GND connect to the breadboard's GND input
The servo connections we use in this project are as follows;
Orange Input - Signal Input
Red Input - Power Input (VCC)
Brown Input - Ground Input(GND)
The Servo1 VCC and GND connect to the breadboard's VCC / GND inputs
The Servo1 Signal connect to the Arduino Digital PWM 3
The Servo2 VCC and GND connect to the breadboard's VCC / GND inputs
The Servo2 Signal connect to the Arduino Digital PWM 5
The Servo3 VCC and GND connect to the breadboard's VCC / GND inputs
The Servo3 Signal connect to the Arduino Digital PWM 6
The Servo4 VCC and GND connect to the breadboard's VCC / GND inputs
The Servo4 Signal connect to the Arduino Digital PWM 9
Source:
Web Site: www.mertarduino.com
Social Media:
/ mertarduino
/ mertarduino
Негізгі бет Multiple Servo Control with Arduino Uno R3
Пікірлер: 277