I started this build approx 6 years ago. I assembled the main frame and added the controls and air cylinder then shelved it. The supplied air in my old shop wasn’t enough to run the hammer so I stored it in a corner.
I’m in a new shop, installed my own air system and pulled this project out of the dust.
This test run is using air supplied from a hose reel. Several neck downs before the air reaches the hammer starves the pneumo. system of PSI and it hits half as fast or slower than it should run. When I run a dedicated air supply from my 3/4” shop air at 120 psi it’ll hit much faster and harder.
Негізгі бет My pneumatic power hammer is DONE.
Пікірлер: 36