After I have cared for a long time little about my MZ ES 150, I would like to do this again increasingly. An acute technical problem let me become aware of a new offer on the Internet. It is a new carburetor from Mikuni, which was prepared for installation in the MZ ES 150 and TS 150. In this video I show the conversion and the result of it.
Have fun watching!
Link to the dealer:
www.ebay-klein...
Information from the dealer:
The new carburetor features the following advantages over the stock carburetor:
better throttle response
stable idle gas
reduced slide jerking
plastic shimmer
constant Mikuni quality
needle valve with rubber tip
drain screw on float chamber
Idle mixture screw can be adjusted from the left side
Scope of delivery:
Mikuni VM24 with matching main jet, stronger throttle slide spring and cable choke actuator
CNC machined intake manifold
CNC machined reducing sleeve for the intake rubber, glued tightly
2x mounting screws M8
2x flange gasket
insulating flange
2x Bowden cable bends
Attention! The original Bowden cables do not fit anymore and would have to be adapted!
Attention!
With assembly, the operating license of the vehicle expires and this may no longer be used in the area of the StVO.
The conversion kit is supplied in a basic tuning. Since each engine reacts differently, however, it is mandatory to check the carburetor setting, if necessary, this must be adjusted. We assume no liability for engine damage caused by incorrect tuning or the like. It is not an original MZ part!
Translated with www.DeepL.com/Translator (free version)
Music:
Divine Life Society, by Jesse Gallagher
and
Fluidscape, by Kevin MacLeod:
Fluidscape von Kevin MacLeod unterliegt der Lizenz Creative-Commons-Lizenz "Namensnennung 4.0". creativecommon...
Quelle: incompetech.com...
Künstler: incompetech.com/
Негізгі бет MZ ES 150: New parts; The Mikuni conversion kit
Пікірлер: 61