Maaaaan, you saved me 1 day of figuribg this thing on my own😊
@mvpolo2k3
3 ай бұрын
Probably more than that, but it really depends on how familiar you are with Fanucs older controls, and lathes in general
@u_solutions_lv
3 ай бұрын
@@mvpolo2k3 nearly zero in both. Have yaskawa j300 controlled vmc, but it is like 10 years newer. And offset measurement is much diferent
@dumpsterdave3710
Жыл бұрын
Yooo right about the time you made this video I bought a used '96 Nakamura Tome TMC18 and it has sat until a couple weeks ago when I got it going. Trying to figure out the Fanuc control has been brutal and I've never programmed or even ran a CNC lathe before (VMC guy). This is a goldmine of stuff I can try tomorrow haha.
@LoveDirt00
Жыл бұрын
Awesome thanks for helping me figure out my homing problem
@bigbattenberg
5 ай бұрын
Great video and channel. I am currently learning to operate CNC on a couple of old Okumas. Cheers from Holland.
@abramfriesen9834
8 ай бұрын
That is good can you make some videos on Hardinge cobra 65 with fanuc 21-t controller
@mvpolo2k3
8 ай бұрын
If i had one....
@cuneyitberkan4874
10 ай бұрын
Hello, how can I unlock 9000 parameters?
@santoshkumarkumar-9861
Жыл бұрын
Hii sir nakamura tmc all kord plez ❤
@DieselRamcharger
Жыл бұрын
tool 1 was off not because the z setter but because you typed 1.8476 instead of the displayed 1.8496 :). Great video! thanks!
Пікірлер: 11