Here is the improved version of my Nanolongrange FPV drone frame. The .stl file for 3d printing the frame can be downloaded for free on Thingiverse: www.thingiverse.com/thing:481... I'm very happy with the results. Next upgrades will focus on the FPV system (different antennas and new RX module). Update: for more range set the VTX to higher power levels (as far as your local regulations allow +25mW). I will also test 21700 batteries and the Insta360 Go 2 on this frame.
0:00-0:16 3d printing the frame
0:17-0:58 design evolution
0:59-1:09 GNB27 connector
1:10-1:40 Immersion RC Ghost Zepto
1:41-1:59 connecting Rx and GPS to FC
2:00-2:19 installing FC
2:20-2:30 installing Rx T-antenna
2:31-3:18 installing motors
3:19-3:35 installing FPV camera
3:36-3:49 installing GPS
3:50-4:08 overview
4:09-4:24 Betaflight setup
4:25-4:40 mounting 18650 battery
4:41-4:51 AUW weight
4:52-5:13 final check/indoor flight
5:14-5:54 first outdoor test
5:55-6:35 fighting strong winds
6:36-8:21 full battery test
8:22-8:37 landing
on.fb.me/unboxingexperience
Негізгі бет Nanolongrange V2 - single 18650 FPV drone with GPS
Пікірлер: 494