NanoVNA: Testing Coax For Characteristic Impedance And Distance To Fault (Length) is my attempt to simplify and demystify some the the cool things you can test on transmission line with the NanoVNA. This is just one of a group of videos I'm doing on this amazing little tool. For most of us in the Amateur Radio Hobby, every new thing we do brings forward all sorts of learning and experimentation. This is just one video I am making in this journey of discovery!
If you want to purchase the NanoVNA shown in the video, it's available on Amazon Prime here: amzn.to/3t9zsB2
And of you are trying to get the majority of the adaptors you need to run tests on different devices, here is a good kit. I wish I had found this when I was digging up all the stuff I needed for testing. You probably will want to buy at least two of these to get setup for both sides: amzn.to/3J8sBxq.
Thanks for watching and hope to hear you on the air!
Chapters:
0:00 - Intro to NanoVNA: Testing Coax For Characteristic Impedance And Distance To Fault.
1:38 - Using the NanoVNA in Smith Chart mode to test coax characteristic impedance.
7:25 - Let's break out the calculator.
8:35 - Proof by example. Testing non 50Ω coax.
12:48 - Testing for length to fault with the NanoVNA.
13:33 - Setup NanoVNA for Time Domain measurements.
15:08 - Formula to calculate the stimulus settings.
17:46 - Taking the measurement.
19:16 - What are the additional 'bumps' on the screen?
22:20 - Closing thoughts.
Негізгі бет Ғылым және технология NanoVNA: Testing Coax For Characteristic Impedance And Distance To Fault (Length)
Пікірлер: 26