I found what you used to hold the wood boards to be very good, very nice idea
@libor-vitek
Жыл бұрын
Thank you Maggie 😘 May be just one note, for next clamps I'd use thinner material, like 1 mm or rather 0,5-0,6 mm inox steel (or another non-magnetic material). Since nozzle of my air assist is located just 2 mm above plywood sheet and sometimes the nozzle "catches" the 2 mm thick clamp 😉
@quetzalcoatlhermeticus8024
2 жыл бұрын
Hi, how much time was needed for this project and did the machine got heated? Ja could it make couple of this one after another?
@libor-vitek
2 жыл бұрын
Hi, if I remember correctly, it took 3,5 hours to burn. Machine was completely fine.
@quetzalcoatlhermeticus8024
2 жыл бұрын
@@libor-vitek for all 6 pieces?
@libor-vitek
2 жыл бұрын
@@quetzalcoatlhermeticus8024 For all. There were actually 8 pieces.
@quetzalcoatlhermeticus8024
2 жыл бұрын
@@libor-vitek thanks, i want to buy laser exactly for cuuting layered art so i dont know if neje would do the work or should i buy xtool 20w
@libor-vitek
2 жыл бұрын
@@quetzalcoatlhermeticus8024 Well, so far I am fully satisfied with my NEJE. XTool 20W might work faster (33% stronger), since my NEJE A40640 has "only" 15W of optical power, but XTool is almost 3x more expensive than NEJE A40640 machine, if I am not wrong.
Пікірлер: 19