Pro Taper XR50 Handlebars on my 2018 KLX 110L ! I made all the stock wires fit! All stock bike except a full Pro Circuit exhaust and now these bars. #klx110 #klx110l #klx
Please check out my other videos and consider subscribing! Thank you (:
@dbk1618
4 жыл бұрын
The kill switch has a little plastic nub on the inside of the back plate that would keep it in place on the stock bars. I shaved it down on mine and put some double sided 3m tape to keep it from rotating on the bars.
@JackFreese727
4 жыл бұрын
Cool I'll def shave it down soon!
@richardstone8615
7 сағат бұрын
Were they tall bars ?
@dbk1618
4 жыл бұрын
also, that wire that goes into the clutch perch lets you use the auto start when you are in gear by pulling in the clutch.
@JackFreese727
4 жыл бұрын
Thanks! I was figuring it was something weird lol
@dylansiess1751
3 жыл бұрын
Hey man I just got done building this exact bike take a drill to the back of the kill switch and e start there a point back there to grind off because stock bars have a hole for that
@jimjim5491
2 жыл бұрын
I think you bought the wrong bars, I bought the pro taper 7/8 xr50 and they fit perfect. Stock wires and bar clamp bolts down tight, perfect fit.
@jeffbigbut6450
3 жыл бұрын
The wire in the clutch is so you can start it in like second or first gear with the clutch in
@JackFreese727
3 жыл бұрын
Yes!
@rayv882
3 жыл бұрын
You have to file down a little notch inside that kill switch and it'll close
@JackFreese727
3 жыл бұрын
Thanks!!
@mikemartinez2012
3 жыл бұрын
I have those bars on my klx 110 and have the Same problem with the clamps hitting the little curve on the bars but it’s fine also the kill switch problem is because there is a little pin thing inside the switch that you need to cut if 😃hope this helps
@JackFreese727
3 жыл бұрын
Thanks!
@travisklo9352
3 жыл бұрын
Your bars are gonna movie when pulling back on them
@JackFreese727
3 жыл бұрын
I tightened them pretty good and filed down a bit to make it easier
@tylergrimes1864
3 жыл бұрын
Are these xr 50 bars supposed to fit a Honda crf 50cc and you just made it work for yours ?
@JackFreese727
3 жыл бұрын
Yeah meant for a 50, I got a good deal on them so I wanted to see if it could work. Which it did, I've ridden twice on small jumps and wide open turn tracks jus fine. They did move twice, but I took a grinder and widened the joint so it secures better
Пікірлер: 20