Fun for the whole family. Your raising them right.
@mrgetthatbag5799
6 ай бұрын
Question, why didn’t you run the exhaust through the exhaust holes in the cross member vs underneath?
@Chickeneyegarage
5 ай бұрын
The clutch fork is in the way of going over the transmission crossmember on the driver side. At the time I didn’t want to under the crossmember and then back up to utilize the exhaust cutout so I just went below everything on both sides.
@edgarfuerte9495
3 жыл бұрын
Pure class! 👌 great vid!
@stevencoughran6115
Жыл бұрын
Charlie ,nice job !, did you order that from summit ? Your welds look good !,
@Chickeneyegarage
Жыл бұрын
Thanks for the compliment.
@raymondtrotter4655
Жыл бұрын
Sounds great. Which Flow Master did you install. I'm looking forward to installing some 40s on my 62 Fleetside Shortbed Big back window. Thanks Trucker Ray ✝️
@Chickeneyegarage
Жыл бұрын
Thanks. Flowmaster flowfx is the mufflers. It’s basically a straight through design similar to a magnaflo muffler.
@raymondtrotter4655
Жыл бұрын
@@Chickeneyegarage okay thanks
@loufresquez8031
3 жыл бұрын
Nice work good job
@kuzz7919
3 жыл бұрын
sounds good !!
@swrmerle
2 жыл бұрын
Just curious, what made you decide not to go through the exhaust cutouts in the crossmember?
@Chickeneyegarage
2 жыл бұрын
On the driver side I can’t get the exhaust pipe above the transmission crossmember because of the clutch fork. So until I figure that part out I just redid the exhaust like before for simplicity. I want to keep it standard so I might do an hydraulic throw out bearing to get rid of the fork and then I can route the exhaust higher
@swrmerle
2 жыл бұрын
@@Chickeneyegarage I am swapping my old 283 for a ZZ4, and have everything apart right now. I did the cutouts already, but haven't put the new motor in or any exhaust yet. I am automatic, so maybe I'll be clear.
@Chickeneyegarage
2 жыл бұрын
@@swrmerle you should have no issues. My 1970 I use to have was an automatic and I had plenty of clearance to raise the exhaust. I had to get rid of the long tube headers and go to mid length. Other than that, no issues.
Пікірлер: 17