sounds good man. in comparison to the OEM exhaust, how tight to the engine is this system? did the headers go out further or hang lower etc etc?
@JL-ep1rb
6 жыл бұрын
AUTOT3K HCL hey, very good question. It was very close during install, I landed up shimming with a piece of wood while I tighten everything up and it stayed in place. About 1 inch away from the indent portion of the oil pan. Runs tight around everything for a clean look and safe as well. Good quality exhaust for the price. I didn’t try it without the quiet insert(sparks arrestor) yet. Winter creeped up on me and want to do a flash ÉCU before I try it
@stesh101
6 жыл бұрын
Good quality? Thinking of getting that system
@JL-ep1rb
6 жыл бұрын
stesh101 very good quality. I was impressed during the unpacking. Very good price as well
@ksprr6856
5 жыл бұрын
Did you use the following exhaust paste?
@JL-ep1rb
5 жыл бұрын
KSPR R yes
@LukeBrinkerhoff
5 жыл бұрын
Still doing good? Did you get a ecu flash?
@JL-ep1rb
5 жыл бұрын
LukeBrinkerhoff yes from Vcyclenuts
@LukeBrinkerhoff
5 жыл бұрын
JL what all did you have him do?
@JL-ep1rb
5 жыл бұрын
LukeBrinkerhoff the standard ecu flash he offers with the block off plates setup. Worked good. Worth it. I’ve sold the bike last year unfortunately
@ronhu6035
4 жыл бұрын
Is this the 300mm muffler?
@JL-ep1rb
4 жыл бұрын
Ron Hu I think so yes
@JonDagata5
6 жыл бұрын
Any idea what mm can that is?
@JL-ep1rb
6 жыл бұрын
Jon Dagata I want to say 250mm not 100% sure
@playingfor4
6 жыл бұрын
Jon Dagata it is 300mm.
@THUvidz
6 жыл бұрын
ECU Tuned?
@JL-ep1rb
6 жыл бұрын
THUvidz yes by Vcyclenutz
@THUvidz
6 жыл бұрын
Nice, did you remove the break away tip of the db killer?
@JL-ep1rb
6 жыл бұрын
THUvidz I did yes to try it but was too loud for the time I leave in the morning. I handed out modifying it though, I cut the restricted small pipe a bit shorter for more sound
Пікірлер: 21