Use washers....... I had rivet pull threw. If you use screws or bolts you might not need worry about replacing but rivets duck to remove.
@FloppyHatPhotos
7 жыл бұрын
With the nuts I have not found a need for washers, I try to not use rivets on anything aside from metal. Thanks for watching. Patrick
@wiggsan
8 жыл бұрын
How did you get the nuts attached to the screws? You didn't show that...
@FloppyHatPhotos
8 жыл бұрын
Sorry I could not get my camera inside the kayak to show that but you can see me place my hand inside to show there is noting inside to hit. You can reach both bolts from the front on my boat. Thanks for watching. Patrick
@wiggsan
8 жыл бұрын
OK. My kayak is not open for me to reach the back side of a bolt. Is there any other attachment mechanism that would be durable that you know of? Thanks...
@FloppyHatPhotos
8 жыл бұрын
That would make it hard, but first thought was a Crown Bolt like used for hallow walls. Be sure to put bolt threw handle before you put Crown threw kayak. Patrick
@getoffyourbassandletsfish7651
7 жыл бұрын
Alex Wiggs rivet gun but make sure to use washers.
@wiggsan
7 жыл бұрын
Thanks!
@oshuntravel1111
5 жыл бұрын
You never showed us you carrying it with the handle.
@FloppyHatPhotos
5 жыл бұрын
@10:17 it shows my picking it up, carring would be the same just moving.
@vlogtimes5400
5 жыл бұрын
What size was your drill bit?
@FloppyHatPhotos
5 жыл бұрын
Mine was a 1/4" but you need to fit your bit to your bolt.
@paulorlando2718
5 жыл бұрын
Didn't show the most important part! Are they screws? Rivets? WHAT?!
Пікірлер: 14