Had exactly the same trouble with the large seal on a UNI housing, not impossible but very tight. Little tip for anyone doing this job without any of the drift tools to hand, a used engine mount is the perfect size to tap down both the bearing and the large seal
@exsoulagent
4 жыл бұрын
Well done that young apprentice 👍🏻 have 3 uni mag housings and great value over the original design
@happyngroovynallthat6708
3 жыл бұрын
Thanks for this. I've just had a similar experience fitting the seal to a brand new Uni housing too. Apart from that they're great value for money and I'd definitely buy another one.
@user-pn2hn5vk3p
2 жыл бұрын
Hi Rob - As I am a total novice on Lambretta rebuilds it may be helpful if when you fit the Mag seals (or any seals) to show the correct wat to fit them . ie. using spring side and flat side, facing yiou facing away or a good pic. Great vids.
@kickbackgarage
2 жыл бұрын
Spring always towards pressure. First thing you need to do is buy Stickies manual.
@mickykeane3847
Жыл бұрын
So both mag seals have springs facing the crank then? Cheers
@kickbackgarage
Жыл бұрын
Yes!
@DavidCornish
3 жыл бұрын
Rob that mag housing looks really good, I’m just rebuilding a 66 SX 150 would you recommend it or stick to sil?
@kickbackgarage
3 жыл бұрын
It's really nice. If you have a sil then use it but if you need a new one, buy a uni, would be my advice.
@maxwonttakethetrain142
3 жыл бұрын
where can i buy one rob?
@kickbackgarage
3 жыл бұрын
As far as I am aware, åf rayspeed are the UK distributor but seen them for sale in quite a few different places.
@menditman2004
3 жыл бұрын
Hi again, I’m just curious how does this bearing get lubricated?
@kickbackgarage
3 жыл бұрын
Only by the grease you pack it with. That's why it's important to use high temperature grease.
@menditman2004
3 жыл бұрын
@@kickbackgarage Thanks for getting back, what grease do you recommend? Thanks.
@kickbackgarage
3 жыл бұрын
I use putoline high temp. Works well.
@menditman2004
3 жыл бұрын
@@kickbackgarage ok I’ll try to get some, thanks for your help 🙂👍
@menditman2004
3 жыл бұрын
Hi again is that the ceramic grease?
@206wrctribute
4 жыл бұрын
Rob, which way does the oil seal holder (ring) go? flat side facing down or up, cheers
Пікірлер: 21