In the Installer’s menu you can customize which Panic buttons are displayed and which ones were not.
@Norcallifesafety
7 ай бұрын
How did you do that
@Msranda2007
7 ай бұрын
The first thing I did was Factory Reset the panel and also removed the Cellular card and internal Siren. Then I wired up the pull station to the Wired Zone 1 Terminals and programmed it as a 24 hr audible alarm since the wired zones can’t be programmed as Fire Zones. Then I hooked the notification appliances to the Bell circuit. I tested it and the system actually worked how it intended it to. The same thing can also be accomplished with the older 2Gig panels.
@Alarmsystems829
6 ай бұрын
@@Msranda2007connect your panel to WiFi and update it. It will add 24 hour fire as an option for the pull stations. Connecting it to WiFi will not connect you to Vivint’s monitoring because your panel was reset, so it will be okay to connect your panel to WiFi.
@Msranda2007
6 ай бұрын
@@Alarmsystems829 Thanks for the information! Currently I don’t have the Vivint Panel hooked up but whenever I hook it up I’ll make sure to update it!
@Alarmsystems829
6 ай бұрын
@@Msranda2007 okay!
@Alarmsystems829
6 ай бұрын
@@Msranda2007 you have to wait 5 minutes after hooking it up to the wifi and update it using the installer toolbox
Пікірлер: 13