Here I present a 'new' way to texture climbing holds that creates a hold surface very similar to a typical molded hold, but without any mold investment.
Here I am using polyester gel coat from my local fiberglass supplier. It is important to a) buy from a well known source and b) do this process at 20°C or above for good longevity
since publishing this video several people have told me about this process being used many years ago which has been wonderful - it seemed so simple it must have been done before and of course there's nothing new under the sun!
Please drop me a line in the comments or on instagram if you have any questions or thoughts: / gbartonowen
/ giles_climbs
Files for some of the holds available here: www.thingiverse.com/thing:526...
Disclaimer: The information presented is for education only and I do not accept any liability if you choose to reproduce some or all of what is discussed. As always, climbing holds can cause dangerous situations, any hold or climbing equipment should be thoroughly tested and validated before use. I am not a certified engineer or route setter and therefore should not be considered a reputable source when discussing safety of climbing equipment.
Негізгі бет Спорт New way to texture climbing holds
Пікірлер: 112