I will be getting this one for my 4052m thanks for the video ☺
@DowdleFamilyFarms
Жыл бұрын
Good choice! I hope that you enjoy it. You should be able to chip slightly larger hardwood material than I do with the additional HP (depending upon whether you have the power shift or hydrostatic transmission).
@victorgillen2439
Жыл бұрын
@@DowdleFamilyFarms how long did it take to get this chipper?
@DowdleFamilyFarms
Жыл бұрын
It took a few months at the time. But sometimes they have them in stock. It depends on their production cycle. It is worth the wait though, if you have to wait.
@alexlavoie5311
11 ай бұрын
Safety first, didn’t see your ear protection. But yes this chipper is on my bucket list
@DowdleFamilyFarms
11 ай бұрын
👍
@patrickriley5821
2 ай бұрын
Running the vid in high speed sure make this chipper look good. A little more and it will beat a 12' Vermeer! ! !
@DowdleFamilyFarms
2 ай бұрын
lol. I see your point, but that was not my intention. Dragging limbs and small trees takes time and I was trying to show how much it can do. I promise you its nothing like a big vermeer or bandit chipper though!
@patrickriley5821
2 ай бұрын
@@DowdleFamilyFarms I know, I have the orange one. I think it's call a WM8H. It works great for what I need. Your's works much better when the time lapse is turned up !
@DowdleFamilyFarms
2 ай бұрын
lol. I bet.
@savageairsoft9259
2 жыл бұрын
Was there a lot of assembly? If so, was it very complicated to assemble? Thanks
@DowdleFamilyFarms
2 жыл бұрын
No assembly at all with the MX-9900. For the most part the machine comes ready to use but you need to add oil to the hydrostatic system. You do this by removing two nuts with your fingers and pour the oil in a tank. Run the machine for a couple minutes per @woodmaxx detailed instructions and then check the oil level again. They hydrostatic system runs on 2 quarts of oil, and it does, but the first time you fill it, the lines and the hydrostatic pump will hold an additional 1/4 of a quart of oil. So have 3 quarts of 10w-40 oil on hand when you get the machine. It took longer to tear the box open than it did to put the oil in the hydrostatic system. You may have to trim the PTO shaft (I did not have to), but that is a fairly normal procedure if you have equipment for a tractor. It comes ready to use other than these two issues.
Пікірлер: 12