The Machine Shop was really great today. We came up with two methods to lock the drive gear to the drive shaft after we install the Ball Bearing. They provided insight, methods and advice. They agreed to build one axle to test. and we would go from there. We think we have a way to achieve Ball Bearings for everyone, at a most reasonable cost. I am going to order a few special tools to help me do a better job. When I got back I worked on this little guy taking data and anding the various modes. Smoke is still not working as smoothly as it should. I will build a new board and verify each part of doing its job properly. I want to increase the wire in a few places as well. Hoping to get this wrapped up and get the truck assemblies built. The new 24 gauge solid copper wire was delivered so we are ready to go. Like to have on the rails Saturday strutting its stuff. Later Gang, D
Негізгі бет Next Gen S Three Amigos, are healed. We know what to do & our action plan is in motion. Puff & Chuff
Пікірлер: 4