Brilliant video dude, hats off to you for tackiling it 👏
@cardiagnosis8199
10 ай бұрын
Thank you for the feedback
@hayche1986
11 ай бұрын
very informative video thank you, would that tooth being out cause a popping sound on deceleration and possibly a 3000rpm vibration by any chance?
@mahmutkocakcom5962
2 ай бұрын
👏👏
@igp3130
Жыл бұрын
Hello mate, did you have to lock the camshafts with a kit or just keep some spanners on them?
@r33gts2009
Жыл бұрын
Hi thanks for the video ,was it necessary to remove the rocker cover ?
@kuidokanarik7455
11 ай бұрын
Hi, do you remember sizes of these o-rings in camshaft covers? Cant find anywhere and only whole cover is for sale.
@NSEMRAIR
Жыл бұрын
How many times did you had to turn it to get back to match on timing marks do you remember ???
@tariqzaman7409
Жыл бұрын
Thank you for posting such a great video, I have the same issue with my 2015 Pulsar. It’s only done 59,000 Miles, the oil pressure warning light is coming on intermittently but the rattling has been present for over 6 months. A local garage mechanic found nothing wrong. Do you have any idea what sort of price this job should cost pls?
@user-iw6bn2vm3o
Жыл бұрын
Похоже на стук цепи ГРМ.
@henrietabacova8285
Жыл бұрын
Hi buddy, the water pump started leaking on my Ulysse 2.0 petrol, just wonder if it's a big job to replace the whole part including housing??
@cardiagnosis8199
Жыл бұрын
Hi . Sorry I didn’t count so I’m not sure . But it take a lot of turns . May up to 20 turn overs. Hope this helps .
@liaquatali-mm2dy
Ай бұрын
I have the same issue on my juke
@rs_99_
Жыл бұрын
Hi.. roughly speaking what could i expect a garage to charge to do this...dealer & indy
@kaikaineilps5
Жыл бұрын
How did you lock the timing if u can tell me please
@Myto321
Жыл бұрын
hello, very helpful vid thanks, what diagnostic tool are you using?
@cardiagnosis8199
Жыл бұрын
Hi It’s a Launch Pro 5 plus
@spanthefestaman
10 ай бұрын
How come you had to take the cam cover off??
@Apuokenas
Жыл бұрын
Do you, by any chance, remember the mileage on the odometer? It's sad that according to the manual, the chain needed to be replaced only after 300,000 km; however, in reality, the actual number is much lower (~3.75 times), no matter that the oil has always been replaced every 6,000 miles or so. 😢
@cardiagnosis8199
Жыл бұрын
Hi This engine had covered 67506 km .
@beatonthedonis
Жыл бұрын
@@cardiagnosis8199 Exactly the time I got my timing chain rattle in a 1.2 Pulsar. Nissan changed it for free out of warranty, because I'd always serviced it at the main dealer.
@ssss-df5qz
5 ай бұрын
This is what happens when you buy cars with crappy French engines in them. I'm surprised your DIG-T didn't blow up from excessive oil consumption before the chain went.
@danisimo1385
6 ай бұрын
Проблему не решили, зато поменяли цепь. Проблема в форсунках-омывателях, где перестает работать клапан и масло стекает/вытекает из блока - нет давления и башмак не натягивает цепь. Сейчас найду видео - кину ссылку.
@danisimo1385
6 ай бұрын
Надеюсь это кому-то поможет
@TheMattyholt
Жыл бұрын
Could this be done without removing rocker cover or not enough room to get chain out? Cheers
@cardiagnosis8199
Жыл бұрын
I don’t believe so as the bolts for the rocker cover go into the timing chain case . I would advise to always follow the repair instructions to eliminate any mistakes . Hope this helps
@chrismills9346
Жыл бұрын
Yeh it can I done one today with out taking rocker cover off 👍
@liaquatali-mm2dy
Ай бұрын
What was the cost ?
@paultownsend3698
9 ай бұрын
Do you need locking tools
@dimvasileiou974
Жыл бұрын
Hi how about oil consumption ; I have the same engine 60k km and mine consumes 250ml per 1000km
@cardiagnosis8199
Жыл бұрын
Hi Unfortunately I’m not sure of the oil usage specs on this engine . I was doing a timing chain replacement . Owner of the car didn’t mention any oil usage .
@user-iw6bn2vm3o
Жыл бұрын
Пробег 89000 расхода масла нет.
@mohamadamen8079
Жыл бұрын
Hi, can you tell me how to find the adjustment tool for this motor?
@cardiagnosis8199
Жыл бұрын
Hi There is not adjustment tool required . The timing marks are on the chain which you line up with the correct marks on the cam pulleys and crankshaft pulley .
@robertoviscardi4326
Жыл бұрын
Numero km? Tank you... 🇮🇪... Ciao
@cardiagnosis8199
Жыл бұрын
Hi 67506 Km the engine had covered .
@robertoviscardi4326
Жыл бұрын
@@cardiagnosis8199 My car Qasqai DIG_T 1200, 7 yer, km 90000...goud! Ok... Ciao🇮🇹
@user-iw6bn2vm3o
Жыл бұрын
@@robertoviscardi4326 Такой же Кашкай. 6 лет 89000 км
@igp3130
Жыл бұрын
Hello mate, did you have to lock the camshafts with a kit or just keep some spanners on them?
@cardiagnosis8199
Жыл бұрын
Hi No didn’t need to lock the camshafts.
@igp3130
Жыл бұрын
@Car Diagnosis cheers man, do they try to spin at all or did you just keep some spanners on them? Gotta do one tomorrow and it's not a engine I know that's all
@cardiagnosis8199
Жыл бұрын
@@igp3130 cams stayed in the position.
@dantolhurst7802
Жыл бұрын
@Car Diagnosis do the cams move out off time wen tension is released off chain...
@Kangoo172
11 ай бұрын
Great video, thank you. Did you need to remove the alternator and a/c pump? Just about to do one on a Juke and the repair manual says to remove them both.
Пікірлер: 44