nice job no part cannon :) I made epoxy repair on fender line where the vibration is much less than on the engine itself despite of it the epoxy could not handle the vibration and broke after a short time. What I prefer to remelt them together with similar materials with soldering iron or using zip ties to melt them together. These worked on my Renault Fender lines so far 2 years from now. ... I tried also whatever called Loctite and UHU plastic glue products without any long term success....:( I have never tried chassis structural glues they might work?
@kennedysgarage3281
7 ай бұрын
The zip tie trick sounds quite handy, I would never have thought of that 🙏🙏🙏
@madfaz
5 ай бұрын
Have the same fault code on a 2013 Qashqai 1.6 dci. No loss of power, no limp mode, just brings on the EML when driving around 50/60mph. Smoke tested fine, no leaks. What am I missing?
@kennedysgarage3281
5 ай бұрын
These are relatively common for egr valves sticking slightly open & causing an under boost. It would be worth looking at 🤔🤔
@kennedysgarage3281
5 ай бұрын
Renault P0488 EGR throttle position fault, Part 1 kzitem.info/news/bejne/jm-Av55noKJ2mG0
@upsidedownrc8992
5 ай бұрын
Peter can ye tell me what the 1.5dci 2007qashqai air flow should be in g/s. Mine is around 12to14 at idle...seems way too much??? Would a mass air flow sensor clean help? Love your work, wish you were closer to kildare🇮🇪👍👍
@kennedysgarage3281
5 ай бұрын
It does seem a bit high, could the egr valve be not opening. Are you getting air flow faults or what is making you question air flow numbers??
@upsidedownrc8992
5 ай бұрын
@@kennedysgarage3281 could very well be...i will see what the scanner is reading in the maf with koeo I think the pcv could be gone..a few seals starting to leak and a bit of oil consumption
@kennedysgarage3281
5 ай бұрын
@@upsidedownrc8992 good luck with it 🤞🤞
@damienkearns9922
Жыл бұрын
Great cartoon Peter and the first 7 mins were every bit as good as the next 7 👍🏻 The drilling of the holes is genius…you are essentially making liquid rivets …🤔🤔🤔 that could be your next new product to market “Peter Kennedys Liquid Rivets “ 😂 ….. it’s the internet Peter…everything sells 😂😂😂😂🤫🤫🤫
@kennedysgarage3281
11 ай бұрын
I’d love to patent and make the timing chain removal tool I made for Mazda’s. It’s a fantastic & simple thing that saves some load of time 😊😊
@markobrien5551
Жыл бұрын
I would get that clutch position sensor replaced as if it is set to the in position it can stop the regeneration process, get it a lot on vivaro’s and Peugeot vans as the cause of a blocked DPF. It could of been the high back pressure that might of blown the boost pressure pipe when the clutch switch was intermittently broken then when it started working again the car has done the regen.
@kennedysgarage3281
11 ай бұрын
That is correct Mark, Clutch position switch can inhibit Dpf regeneration. But the normal crack of I’m getting rid of the car, so I’ll leave it for now 🤷🏼♂️🤷🏼♂️
@barrycoleman4686
Жыл бұрын
Check the injector that goes into the exhaust. Similar to the vaporizers in the ford's. They clog up badly so dpf won't heat up to regenerate. I think it's putting back pressure on to that pipe. Did one last week. And did I laguna where it broke the turbo shaft due to back pressure. Easy to take out. 3x 10mm bolts.
@kennedysgarage3281
11 ай бұрын
It caused the turbo to break, wow. Cars are crazy nowadays. Those injectors catch out a lot of people, same thing on Toyotas 😉🙏🙏
@davidmehlhorn726
Жыл бұрын
That pipe is a common fault on Qashqai j10 models. I’ve a 2011 Qashqai and that pipe lasts exactly two years before it snaps, regular as clockwork. I carry a spare one in my boot with a small socket set so I can replace it when it goes as it’s a simple five minute job. As I last replaced it in a November 2021, I’m just counting down the days until the current one snaps, most likely in the next month🙄🙄🙄
@kennedysgarage3281
11 ай бұрын
Wow, handy to have the spare one there so David. I could be after improving on the original on so 🤞🤞😬😬
@davidmehlhorn726
11 ай бұрын
@@kennedysgarage3281 Your fix was a good one that’ll probably make that pipe stronger than it was originally. As you know, that turbo inlet pipe is just plastic and with the heat of the exhaust, and engine vibration, it’s a given that it’ll break eventually. In my case, it snaps on average every two years without fail (excuse the pun🙄). I’ve been badly caught out in the past when it broke leaving me in limp mode miles from home and struggling to get home. If you drive too far with it broken, the car will eventually stop dead and won’t restart. So that’s why I now carry a spare one in the boot as a simple five minute job replacing it will have me back in the road in no time as opposed to sitting waiting for a tow truck for five hours which happened in the past! Keep up the good work with the videos. I’m always willing to learn new tricks👍👍
@kennedysgarage3281
11 ай бұрын
@@davidmehlhorn726 it blocks the Dpf if driven to far after it breaks, thank you very much for your support 🙏🙏
@johnbarry5368
Жыл бұрын
Def is definition so for the one fault code you can have different definitions of the code as in high voltage low voltage overboost underboost
@kennedysgarage3281
11 ай бұрын
Oooh, now that’s interesting. That’s something I need to do some research on 👍👍👍
@petecurran3995
Жыл бұрын
A top fix there, Peter! Probably outlast the motor! 💪🏻
@kennedysgarage3281
11 ай бұрын
So far so good anyway Peter 😊😊
@colmmccabe2998
Жыл бұрын
Fairly common it's great now we can get that boost pipe spurious now.
@kennedysgarage3281
11 ай бұрын
Wow, I didn’t actually know that. Thank you Colm 🙏🙏🙏
@colmmccabe2998
11 ай бұрын
My parts supplier here in athlone gets them for me anytime I'm looking for one
@michaelcoughlan1123
Жыл бұрын
Brilliant fix Peter.
@kennedysgarage3281
11 ай бұрын
You liked that one Michael, thanks for watching 🙏🙏
@rabmoir
Жыл бұрын
DEF Diesel exhaust fluid
@kennedysgarage3281
11 ай бұрын
Brilliant & handy to know. What the heck would the put that in a boost pressure fault for 🤷🏼♂️🤷🏼♂️ I normally see ‘diesel exhaust fluid’ in adBlu faults 🤔🤔
@rabmoir
11 ай бұрын
@@kennedysgarage3281 He who composes the software 😂😂
@kennedysgarage3281
11 ай бұрын
@@rabmoir we also must be mind readers 🤷🏼♂️🤷🏼♂️🤷🏼♂️ Thanks mate 🙏🙏
Пікірлер: 34