Today at Ugly Truck, we’re fabricating another low mount AC compressor bracket for another 5.3L LS swapped squarebody C10. Jerry’s first bracket design used a stretch fit belt, which led to some issues. So today, we’re using a belt tensioner and thicker steel for the perfected compressor mount! Be sure to check out the first video for more info!
Check out the FIRST BRACKET DESIGN here! • Don't NOTCH That FRAME...
Here's a list of what we used:
3" x 3/8" steel flat bar
1 1/2" x 3/8" steel flat bar
3/4" x 3/4" steel square bar
11/32" drill bit amzn.to/3PiFg63
10 x 1.50 mm tap amzn.to/3Tt4j92
OE Tensioner - Gates 38159 amzn.to/3Iw4J8m
OE Size Belt - Gates K040378 amzn.to/438sXPy
Updated Tensioner (smaller pulley, more travel, we like this one!) - Continental 49276 amzn.to/3wXYKXb
One Size Up Belt (easier to install) - Gates K040382 amzn.to/43gwImc
For more LS swap tips and tricks, click here! • LS SWAPS - Tips & Tric...
Follow us on Facebook! fb.com/uglytruck
Check us out on Instagram! @uglytruckexperience
Want to send us something? (NEW address!)
7915 E. Division St.
Strafford, MO 65757
TBAAJCNA9XZXIVUI
#lsswap #squarebody #shopdog #coupleswhowrenchtogether
Негізгі бет Автокөліктер мен көлік құралдары NO NOTCH NEEDED! - 2nd Design LOW MOUNT LS Swap AC Bracket - UTX
Пікірлер: 69