One of the most custom fabricated body iv seen on market. Smoov az transition too. Real Powder coat too. 12-15k
@TrevorFoster-l5m
7 ай бұрын
What about my factory back up sensors and blindspot system that's in my factory tail lights?
@jfdb59
8 жыл бұрын
I'm really liking this one. This may be the solution for maximum tool storage without the atrocious looks of a conventional utility bed. I'm assuming the space in the center is 4' wide for sheet materials?
@rondotrailer
8 жыл бұрын
+jfdb59 Yes. Also a little storage under bed. See door just under tailgate.
@andersonlynn3686
Жыл бұрын
You need shelving in the boxes
@rondotrailer
Жыл бұрын
That's available. Thanks!
@paulgrimes2864
8 жыл бұрын
Nice job with the video; good photography and explanation of features.
@ramibanjer
7 жыл бұрын
Hello I liked your design of the trailer
@d13bowman80
6 жыл бұрын
Would there be any way to set up a fifth wheel with this bed?
@bobfleming3400
4 жыл бұрын
A couple of things they could improve: the chains in the rear compartments have already worn the paint, and that big door on the front looked like it had a lot of flex when he let the strut open it all the way. Nice looking bed, but it could be just a bit better.
@harleyhoracio1
3 жыл бұрын
Completely agree. The chains need a pliable plastic sleeve over them. There needs to be a couple of drains in the shovel compartment and Powdercoating you either over-do it or don’t do it at all. Better prep and 2 stage application would do it. But hey, it’s already too expensive but if they wanted to appeal to guys that drive long distances, make provisions for a 60 gal fuel cell.
@harleyhoracio1
3 жыл бұрын
Electric locks and a key fob to control them. 😬
@s.o.f.fpatriotsforlife414
4 жыл бұрын
I have one of these beds my only complaint is that it's only 4 years old and the powder coat job was absolutely terrible on it and a heads up this bed is 1790 pounds
@rondotrailer
4 жыл бұрын
We've found that powder coat back then was not so good. Most manufactures use a primer now. It's a very touchy process. Great bed though. Thanks for comment.
@averagejoe5143
4 жыл бұрын
wow, my SD bed is so different than mine.
@tylerlee4919
2 жыл бұрын
do the Norstar beds come with a resister built in to the tail lights?.
@robertwhillock1144
6 жыл бұрын
Very nice bed would look great on my truck, but the lock are shit in the northwest
@josephguerra4835
7 жыл бұрын
can u do a video with single.wheel.shortbed
@s.o.f.fpatriotsforlife414
4 жыл бұрын
I have one of these amazing bed and lots of compliments but powder coating job is horrible on mine bed also weight 1800lbs so beware otherwise I love it
@rondotrailer
4 жыл бұрын
Yeah, our experience with powdercoat hasn't been the best. A good paint is as good or better.
@s.o.f.fpatriotsforlife414
4 жыл бұрын
@@rondotrailer I had to have mine repainted I only wish this was wider
@enriquediaz6444
5 жыл бұрын
Do they make one for a 1978 Ford F 350 dully
@richardgavin6712
5 жыл бұрын
Do Norstar make a traxemen truck body for 2018 and 2019 Chevy Silverado 5500hd and 6500hd medium size truck ?
@cabbyhubby
7 жыл бұрын
Does that center back light get in the way of you vision through the rear view mirror?
@rondotrailer
7 жыл бұрын
nope
@shortyd427
3 жыл бұрын
I’m looking to do this on a 2015 2500hd Denali. Is it available? & possible to be color matched?
@rondotrailer
3 жыл бұрын
Give us a call 815-899-4340. Body shop would scuff and re-shoot.
@justotorres8970
4 жыл бұрын
Is it the same bed for a single wheel and dually long beds ? And what's the price of that bed?
@finallyholdingontoletitgo1607
Жыл бұрын
About $10,000 to $25,000.
@srvjediknightsrv750
7 жыл бұрын
WOW I M SOLD .... just need to cut a door for the fuel pump bwahahahahahahha
@pauldavid1097
9 жыл бұрын
where are you located, installation costs on a 2015 Ram 5500 cab/chassis?
@rondotrailer
9 жыл бұрын
Paul David 1115 E. State st.Sycamore, IL 60178 Install is ~$800Thanks, Fred 815-899-4340
@selamiunal6172
7 жыл бұрын
rondotrailer
@tdmjason
6 жыл бұрын
I want one but man oh man the price is up there. Do they make an all aluminum one?
@rondotrailer
6 жыл бұрын
No, just steel. The powdercoat is great though.
@leehancock2782
5 жыл бұрын
Aluminum would be 3 times this price i bet
@aidanflaglor5640
4 жыл бұрын
@@thorseim7177 try canada lmao my car dissolved.
@budrespini
5 жыл бұрын
What is the weight of this bed?
@rondotrailer
5 жыл бұрын
About 1200 lbs
@LemonySnicket-EUC
6 ай бұрын
@6:00
@rvadventures
2 жыл бұрын
I was looking but after 7300+ negative reviews on these type of steel beds I've decided to go with aluminum custom bed. The powder coat is a cheaper cut and the beds rust within 30 days of owning them. Do yourselves a favor get a aluminum bed. Look at this video you can see the rust in the beds that aren't even on trucks yet. Shows the poor quality.
@codyanastasoff7090
6 жыл бұрын
How much and will it fit an international 4900
@rondotrailer
6 жыл бұрын
Yes we can get one to fit your truck. We need to know if it's an 60 or 78" CA (Back of cab to center of rear axle. Give us a call. 815-899-4340
@elcabranano4083
5 жыл бұрын
I need one that fits on f150 1997
@LemonySnicket-EUC
6 ай бұрын
It would make it squat.
@HectorHernandez-kc3xk
7 жыл бұрын
Can is be put on a 3500 mega cab 2012
@rondotrailer
7 жыл бұрын
Yes, Norstar makes a bed that fits your truck exact.Give us a call and we can get it going for you.Thanks, Fred 815-899-4340
@Weldhapi
6 жыл бұрын
i want this bed! i dont see it on the cm site
@rondotrailer
6 жыл бұрын
This is a Norstar, check their site. www.Norstartruckbeds.com we sell them too. This is my favorite utility bed.
@rondotrailer
6 жыл бұрын
Thanks for heads up. Fixed. @phuck ewe
@carlbeard4107
4 жыл бұрын
Is anyone making these beds with over a 30k limit?
@rondotrailer
4 жыл бұрын
Not yet, but the race is on. Soon like the pickups they will be at semi rating! 80K :)
@nathancampbell390
9 жыл бұрын
How much is it?
@rondotrailer
9 жыл бұрын
nathan campbell About $6500. We can install or deliver too. Thanks.
@somyemgarden1445
6 жыл бұрын
You got for Toyota tundra
@rondotrailer
6 жыл бұрын
What is your frame outside to outside? What is your CA? (back of cab to center of rear axle)
@Skiworx
7 жыл бұрын
Do you still sell Norstar?
@rondotrailer
7 жыл бұрын
Yes
@Skiworx
7 жыл бұрын
Yes I called and talked to Ed yesterday. Very nice guy. Wish you guys where closer!
@lesgarneau1
7 жыл бұрын
Someone should help the narrator/videographer with the correct terminology for the components on this.
@rondotrailer
7 жыл бұрын
Correct terminology? Where was my grievous error? Also have a little grace, I'm not a news castor...or did I say that wrong? :)
@MistAtsiM
7 жыл бұрын
Nice but 2 much
@ramibanjer
7 жыл бұрын
Can you help me .
@rondotrailer
7 жыл бұрын
wE CAN ORDER ONE FOR YOU.
@ramibanjer
7 жыл бұрын
Unfortunately Aroed Fund is not complete.
@ramibanjer
7 жыл бұрын
l need the samll door at the rear end . In fact I want to buy two .
Пікірлер: 68