So weird watching the Isolastics at work with the engine rocking up and down.
@saywhatsaywhat1
5 жыл бұрын
Yeah , lol my phone really made it noticeable, normally not that obvious but at least you can see the iso system at work
@gregbrassington9369
5 жыл бұрын
Hi , what brand of tyre? as want to purchase the same. Cheers Greg.
@saywhatsaywhat1
5 жыл бұрын
Stock Dunlop K81size 4.10x19 front and rear
@streetscrambler8075
5 жыл бұрын
Sounds good, does the single carb conversion effect performance much ?
@saywhatsaywhat1
5 жыл бұрын
Not perceptibly to me, it's been said the single carb makes less peak power. I've ridden both and there's not much in it IMHO. Starts easily and has a faster idle with the choke on which is nice.
@saywhatsaywhat1
5 жыл бұрын
IMHO it's smoother, probably not as much top end but if you're after that, get a proper modern bike eh?
@streetscrambler8075
5 жыл бұрын
Commando Specialties well l bought a 73 850 a couple of weeks ago , the carbs were miles out but l did a bit of research on the the internet and have managed to set them up without to much trouble it seems to run and tick over quite nicely now.
@streetscrambler8075
5 жыл бұрын
Hi there, do you run the stock front master cylinder on your Commando or have you upgraded to the Andover Norton 13mm one. Regards
@saywhatsaywhat1
5 жыл бұрын
This one has the 13mm kit yes, I do like the improvement in feel. Stock Commando setup is bit wooden.
@streetscrambler8075
5 жыл бұрын
Commando Specialties good l want to do the same to mine but they are out of stock at Andover Norton and not due in until July, so l will just have to be patient.
@tonupturner
5 жыл бұрын
Mikuni?
@saywhatsaywhat1
5 жыл бұрын
Yep, works pretty good too.
@tonupturner
5 жыл бұрын
@@saywhatsaywhat1 VM36? I'm having issues fine tuning mine at the minute. I wondered if you could tell me what settings yours is on? How many turns on the air & idle screw? I know no two are the same but it gives me something to go on.
@saywhatsaywhat1
5 жыл бұрын
@@tonupturner Well, you are just talking about the idle, so start the mixture at about 1 turn out and get the idle speed close and readjust mixture. If it isn't running properly then this won't fix anything over an idle/low speed transition. Pilot jets plug up pretty easily these days if you let the bike sit for more than a few weeks.
@tonupturner
5 жыл бұрын
@@saywhatsaywhat1 So set the idle first then the mixture? What RPM do Commandos happily sit at? & is this best done on a cold engine after start up or after a good 20 minute ride when everything's warmed up?
@saywhatsaywhat1
5 жыл бұрын
@@tonupturner Well, hot idle should be about 1000 rpm
Пікірлер: 18