Part three, rear assembly. This was tricky and required the normal take-apart, fixing my mistakes, and reassembling. Don't worry, I saved you from that and only showed you the good stuff.
Here is the stuff used:
Sanding block: amzn.to/3SwZ8Da
Sanding Sticks: amzn.to/3VCjegX
Pin Vise: amzn.to/3VAL1hY
Metric Drill Bits: amzn.to/3VVzDi3
Gorilla Glue Minis: amzn.to/49zcIgp
M2 Nylock nuts: amzn.to/3VwOGxj
Table of Contents:
00:01 - Introduction
01:03 - Prep A-Arms
02:38 - Rear Bulkhead
04:45 - Rear Shock Tower
05:15 - Rear Turn Buckels
09:07 - Wing Mounts
11:19 - Attaching Rear Shock Tower
11:51 - Stripped Screw Trick
12:37 - Cutting O Rings
13:15 - Rear Hubs
16:34 - Marker
Негізгі бет Тәжірибелік нұсқаулар және стиль NRC K24 Build Part 3 Rear Assembly
Пікірлер: 4