Video shows the assembly of a typical Doorbell Button (This one is a Nutone). The replacement of the Light Bulb is detailed as well as some maintenance & repairs which were completed. Not mentioned is the fact I disabled the electrical by removing one lead from the low voltage side of the Doorbell transformer. If you are not familiar with doorbell wiring, then I say you should have someone else do this work. Voltage for a doorbell is typically 16-24 Volts. You can disconnect the wires at the button without too much caution as long as one does not continually short them out or the transformer can be burned or shorted out!! I also polished the button metal cover with metal polish before completion of the install. The lighted bulb is a constant "On" situation due to the design of the button.
PS: In order to protect the wires behind the button, I added "Shrink Tubing" to the over exposed areas. You slide this tubing onto the wire after cutting it to fit and then can use a heat gun (Maybe Hair Dryer as well) to "Shrink" the tubing snug onto the wire. Much like replacing the missing cover on the exposed wires.
Негізгі бет Тәжірибелік нұсқаулар және стиль NUTONE LIGHTED DOORBELL BULB REPLACEMENT
Пікірлер: 1