Episode 215 - Part 4 Oak nightstand with a drawer - front assembly, milled legs and oil-wax protection /
I put the front on the previously installed drawer and squeeze it with clamps. I screw the front to the drawer with screws into previously drilled holes. I sand the entire cabinet body with a triton eccentric sander. From the waste of oak plywood on a saw, I cut the legs at an angle on a k690s circular saw. I also cut the ends of the legs on a saw at a 5-degree angle. I pass the legs through the ad741 thicknesser to the appropriate thickness. I put a milling head on the f700z milling machine, the rounding cutter bends one side of the leg. Of course, I mill with feed. I grind my legs and mill them for dominoes. I mark the dowels on the frame and use the Festool Df500 to cut the joints. The legs are joined with kleiberit glue and domino pins. I squeeze the whole thing with wolfcraft screw clamps. I remove the excess glue with a chisel. I secure everything with kemihal oil-wax.
#mebletwojegopomyslu #mtp #wood #woodworking #felder #festool #steblo
Негізгі бет Oak bedside table with a drawer - front assembly, milled legs and oil-wax protection
Пікірлер: 30