Remember the Mangrove Mountain Dam survey pillar we built?That's when I got educated on the what happens when it's not quite secure enough.
@adelmocardoso6680
Жыл бұрын
Very good boy
@netballqueens9137
2 ай бұрын
Where are the soldiers in the formwork??
@ronwilliams1656
Жыл бұрын
I used some pieces of bed rails I cut about 6 inches long and screwed them in to the side FORM boards whereas needed and up against the end board with roofing screws. That stoped it COLD from moving ever moving outwards again!!!
@offthegriddownunderaustral8814
Жыл бұрын
Good Idea Bro! I will do a vid on the result of the tech screw systems, it worked perfectly no movement. I would love to see a bit of your work it is an awesome product.
@ronwilliams1656
Жыл бұрын
@@offthegriddownunderaustral8814 Tanks for getting back to me on this. Come to think of it I screwed to both the side board and the end board. 4 screws in each 6 inch piece of bed rail. My forms are two sheets of 3/4 inch plywood glued and screwed together. I had no bulging either.
@netballqueens9137
2 ай бұрын
There is a bow because you dont have soldiers. The walers are to hold the soldiers in place. You then need a lot less Z bars.
@hamzamohamed1039
9 ай бұрын
Geez
@AbdullahAlNour-ri9hz
Жыл бұрын
What's the story with the hair? I want to know :)
@offthegriddownunderaustral8814
Жыл бұрын
Thanks for asking I will tell the story in the next video.
@jamesrowlands8971
8 ай бұрын
What do the numbers on the LVLs mean?
@offthegriddownunderaustral8814
8 ай бұрын
The numbers and Letters allow us to know which boards match with which board eg Number 1 and A match, 2 and B etc. The boards have the hole drilled for the threaded rods. It is so the holes match up for the threaded rods, My own system I have developed, you can call me a genius later.
@jamesrowlands8971
8 ай бұрын
@@offthegriddownunderaustral8814 ah, that's a good idea! The alternative would be spending lots of time lining up your holes so they all match. Or checking each board as you go.
@fatihbilgin1075
9 ай бұрын
Is rammed earth ideal for cold coutry i see most people using it in hot climate country.
@jamesrowlands8971
8 ай бұрын
There's rammed earth buildings at Dinner Plain in the Vic high country. They ran into some problems with erosion due to snow piling on the bottoms of the walls. There are recommended additives to prevent damage from frost. Many people who do rammed earth in colder environments add an insulation layer on one side, or in the center of the wall.
@ulgaire
8 ай бұрын
check Martin Rauch design which he came up with smart solution for erosion in his rammed earth construction ,( austria, german climate)
Пікірлер: 16