Thank you so much for making this video 👌🏼 great english by the way
@vothuat
2 жыл бұрын
Thanks. Glad that you like the video.
@jasonharley8230
7 ай бұрын
Excellent video !!!!!!!!
@edkim5163
2 жыл бұрын
Thanks for the video. Would you mind telling me sizes of the hex wrenches/sockets you need?
@vothuat
2 жыл бұрын
There are 3 hex nuts with size: 5mm,12mm and 14mm For the mesh filter (plastic filter) you can use the Spark Plug Opener (Smaller end) in the toolkit to remove it.
@thefuture8173
Жыл бұрын
35 minutes too long. Already is a video on KZitem on the 821 oil change by Holdfast.
@juanfernandezbenito7096
8 ай бұрын
Could you tell me the tightening torque of the screws and the filter?
@vothuat
8 ай бұрын
There are total 3 screws and 2 filters. 3 screws: (video 5:16) ~ They are all come with the gaskets. So, I recommend you replace the gasket or reuse it only one time. The smallest one: 18~22Nm. I decided 20Nm The next one (under the oil pan): 22~28Nm. I decided 27Nm The last one( on the side oil pan): 38~46Nm. I decided 43Nm 2 Oil filter: The bigger(replaced with new one) : 10~12Nm The plastic one (video 14:35): Unknow but hand tightening is enough, don't do it too hard.
@juanfernandezbenito7096
8 ай бұрын
Muchas gracias
@Zionguyen
2 жыл бұрын
bạn ở quận mấy vậy
@keltecdan
2 жыл бұрын
@@vothuat Your bike looks very clean.
@vothuat
2 жыл бұрын
@@keltecdan Thanks. Actually, The bike is more than 3 years old and I had just washed it before making this clip.
Пікірлер: 13