Usually you add some oil in the filter before screwing it on
@TheNomadMechanic
Жыл бұрын
That is absolutely a good practice
@Satchmoeddie
7 жыл бұрын
Muchos gracias! You used a 14mm socket, not 9/16".. Everything is metric now! I will have to convert newton meters to foot pounds, but that's easy enough. Salud!
@christianiglesias6901
6 жыл бұрын
What’s the torque spec for the oil cap? 😂
@jmesh796
7 жыл бұрын
Wow very nice well done
@gaboss2734
3 ай бұрын
I have a question: those tools that you use to remove the screw so that the oil comes out, how much strength does it have since I had one and couldn't remove it?
@TheNomadMechanic
3 ай бұрын
Not sure if I understand your question, if you are talking about the ratchet, that was a 1/2 in drive and strength wise is the user strength not the tool itself.
@Leduan81
7 жыл бұрын
Just bought a 2016 sentra and was womdering where the oil filter was, since i havent done oil change yet since i bought it, thr first oil change was done at the nissan dealer, i think now i will do it myself, since i dont have time to spend half a day at the dealer for an oil change
@charkee167
7 жыл бұрын
Leduan81 I have the same model. If you were to stand exactly where the Nissan emblem is. The ln go under the car maybe a foot deep.. It's covered by a plastic aerodynamic piece BTW... It should be right there. The drain bolt is there too. It's not facing you. It's facing the rear of the car. You need some equipment if you been doing it elsewhere because they tighten the shit out of it. Which you only have to hand tighten... Anyways you need to buy 0w20 oil and oil filter. I use mobil1 synthetic and mobil1 M108A filter. You may also need a oil filter wrench. Preferably the one you see in this video.. Because like I said it's kinda covered. You may also need a ratchet wrench. You can probably borrow all these from a friend... Also a jack...
@mustafanaji6591
2 жыл бұрын
Great car.
@rollylags
6 жыл бұрын
can u do a manual transmission fluid flush for b17 video?
@jessejames3988
4 жыл бұрын
Thank you
@TheNomadMechanic
4 жыл бұрын
You are welcome!!!
@charkee167
7 жыл бұрын
For me I usually just hand tighten it and it seems fine. So the other times I did a oil change I didn't really need any tools.
@TheNomadMechanic
7 жыл бұрын
That is a common practice and there is nothing wrong with that
@jmesh796
7 жыл бұрын
Make some more video
@RedneckPCtech
6 жыл бұрын
Oil filter should be hand tighten not wrenched on.
@jmesh796
7 жыл бұрын
I have Nissan Sentra 2016 first change oil at jiffy lube coz $81.00 dollars the second one at Nissan service center coz $125.00 dollars
@TheNomadMechanic
7 жыл бұрын
You can do it for a fraction of that cost
@gemerial2808
4 жыл бұрын
I go to the nissan serv dep and use coupons they send me. Never pay more than $36
Пікірлер: 20