Crear fixx sir the wife Thou she aint gon be too happy you using her tamales pot for your hydraulic oil. Lol.
@swbeene0747
4 жыл бұрын
what did you use to fabricate the puller head. I have a Case JX55 with the same seal and bushing and would like to fabricate a "LIKE KIND" puller, but would be a help to have dimensions of puller head and keeper. did you Cnc the head or was it a part that can be found without machining.
@RogersFixItBarn
4 жыл бұрын
Thanks for watching the video. I have a lathe so the puller head was turned to just go thru the part. i will get it and make a sketch of it for you. The all thread is 1/2 -13 the flat down the side was to hold it over to one side and lock it in the grove. The keeper was part of a old butter knife you can see part of the design still on it.
@swbeene0747
4 жыл бұрын
@@RogersFixItBarn Thx for the prompt reply. Im gonna start this project next week and any help would be appreciated.
@swbeene0747
4 жыл бұрын
ok, I fabricated the tool and got the bushing out but now I'm wondering how you pressed the bushing back in. it is a very tight fit. I'm sure it will require some sort of press to press it in. just looking for suggestions as to how to reinstall the bushing.
@RogersFixItBarn
4 жыл бұрын
@@swbeene0747 after I installed the seal in the part I slide it over the shaft and use the shaft to line up the part. I then slide one of the spacers over the shaft and use a hammer to seat the part back in place. the shaft keeps the part lined up as you hammer it in. good luck Roger email me at RLoveC1@aol.com
@swbeene0747
4 жыл бұрын
@@RogersFixItBarn Thx Roger that helps a lot. I appreciate your help.
@kalebkraft7630
5 ай бұрын
Where did you find the seal to replace them? I can’t find it on the internet anywhere
@RogersFixItBarn
5 ай бұрын
I went to the Case dealer and they had the seal.
@davidcantrell313
2 жыл бұрын
Once the tool drops in behind the seal could I drive the shaft back trough driving the seal out?
@RogersFixItBarn
2 жыл бұрын
yes you could drive the shaft up against the tool and drive the part holding the seal out. I did not know how tight the part was pressed in and did not want to damage the shaft.
@aaronbemboom5594
2 жыл бұрын
I had the same problem got the new seals in but were do I add the fluid?
@RogersFixItBarn
2 жыл бұрын
The hydraulic fluid is the gear oil in your transmission rear end. Mine has a dip stick in the fill hole.
Пікірлер: 16