Old Troy-Bilt Horse iller Drive Shaft Seal Replacement - Now Your Tines Won't Turn
After changing the axle seals and rear tine seals • Old Troy-Bilt Horse Ti... , I noticed the drive shaft was leaking oil as well. These old Troy Bilt tillers work great and are so reliable that it's worth putting some money into them to keep them going. This one has the 6 HP Tecumseh engine and serial number 376543. Since I already was going to drain the gear box, I decided now was the time to go ahead and change out the drive shaft seal. I also had to figure out why my drive shaft had too much play in it. After all this, the tines wouldn't turn. In the end, I got it all back together and it's working great!
Drive Shaft Replacement Seal: amzn.to/43qinlm
Aircat Air Ratchet: amzn.to/3DapZOp
SAE 140 Gear Oil: amzn.to/46OfLRe
Axle seal and rear tine seal replacement: • Old Troy-Bilt Horse Ti...
My KZitem Channel: / @therustichandyman
Thank you for visiting my KZitem channel. Please understand that the content on this channel is intended for informational purposes only. I make no warranties about the completeness, reliability and accuracy of this information. Any action you take upon the information posted on my KZitem channel is strictly at your own risk, and I will not be liable for any losses and damages in connection with the use of my KZitem channel.
As an Amazon Associate, I earn from qualifying purchases.
KZitem Channel: / @therustichandyman
Contact me at: rjlifeworks@gmail.com
Thanks for watching!!!
00:00 It's time to change this seal
01:03 Serial number location
01:16 Motor shroud removal
01:34 Lever linkage removal
01:47 Pin removal
03:04 Belt removal
03:32 Motor removal
04:13 Gearbox pulley removal
04:32 Snap ring removal
05:19 Drive shaft collar and seal removal
06:10 Tiller handle removal
06:25 Gear box lid removal
07:04 Troubleshooting excessive drive shaft play
07:16 Shimming drive shaft bearing
08:59 Reassembly of drive shaft collar
09:18 Drive shaft seal installation
09:34 Snap ring installation
09:36 Gear box pulley installation
09:55 Gear box oil fill
10:43 Gear box lid installation
11:32 Handle reinstallation
11:40 Motor reinstallation
11:51 Motor pin reinstallation
13:22 Lever linkage reinstallation
13:40 Motor shroud reinstallation
14:06 Trial run - Tines aren't turning
14:30 Tine shaft exposure
14:42 Why tines won't turn
16:06 Key reinstallation
16:32 Rear tine casing reassembly
17:38 Garden trial
Негізгі бет Тәжірибелік нұсқаулар және стиль Old Troy-Bilt Horse Tiller Drive Shaft Seal Replacement - Now Your Tines Won't Turn
Пікірлер: 36